Allied Telesyn International Corp FastPrint Server Installationsanleitung PDF herunterladen (Seite 15)

FastHub8 and FastHub16 Installation Guide

Powering on the Hub

Apply power to the FastHub8 and FastHub16 as follows:

1. Plug the power cord into the AC power adapter.

2. Connect the DC cable from the adapter into the hubs’ DC input.

3. Plug the power cord into the correct AC power source for the adapter.

4. Verify that the Power LED lights (see Table 1).

If the Power LED is OFF after performing these steps, refer to Chapter 3,

“Troubleshooting” on page 11 for further instructions.

Table 1

FastHub8 and FastHub16 LEDs

LED Color State Description

Power Green On

The unit is receiving power, voltage is within the

acceptable range, and the power supply is

working.

Off

No power.

Collision: 10M

100M

Amber Flashing

The unit is experiencing data collisions on the

LAN segment. It is normal for this indicator to

flash on occasion.

Off

Normal operation.

100M (Ports) Green On

The port is operating or configured (Ports 1 or

Port 2) for 100 Mbps.

Off

The port is operating or configured (Ports 1 or

Port 2) for 10 Mbps.

Link/Activity/

Error

Green

(Link /Activity)

The port is connected to a active repeater or

adapter and the link is active.

Flashing

The port is receiving data packets.

Off

No link to an active repeater or adapter.

Amber (Error) Flashing

or On

Error detected, port is partitioned.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

Allied Telesyn International Corp FastPrint Server Installationsanleitung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Drucken & Scannen Allied Telesyn International Corp FastPrint Server